Network information from front panel display Select Menu > select Network > make note of the IP Address and MAC Address of your device. To ensure that your AudioControl device is connected to your network you can use the front panel buttons and display to confirm that your unit has acquired an IP address from your network router. If you want to assign a static IP address to your AudioControl device you can do so after Dirac calibration is complete. DHCP mode is enabled by default in your AudioControl devices settings. It also makes troubleshooting any connectivity issues much easier. It is recommended to have your AudioControl processor or receiver operating in DHCP mode while running Dirac so that it (and your computer) will acquire an IP address automatically from the network routers DHCP server. We also recommend a wired connection for your laptop computer if possible, but a WiFi connection will also work. ![]() ![]() For your AudioControl device, connect an Ethernet cable to the rear panel Ethernet port and then plug the cable into your home network router or network switch. Please refer to this Setup Menu article on how to navigate the setup menu options of your processor or receiver using the front panel buttons and display of your processor or receiver.įirst, make sure the AudioControl X9 / X7 processor or XR8 / XR6 / XR4 receiver and your computer are connected to the same network (SSID). ![]() Initial Setup of your X9 / X7 processor or XR8 / XR6 / XR4 receiver and home network
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |